|
|
|
National Stock Number:
5365-00-004-6929
Federal Supply Class:
5365
National Item Identification Number:
000046929
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| L44000-11-10 | 17564 | AIRGLAS, INC. |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 2 | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 1.615 INCHES MINIMUM AND 1.635 INCHES MAXIMUM | | HOLE DIAMETER | 0.365 INCHES MINIMUM AND 0.385 INCHES MAXIMUM | | OUTSIDE CORNER RADIUS | 0.350 INCHES MINIMUM AND 0.410 INCHES MAXIMUM | | OVERALL LENGTH | 2.375 INCHES MINIMUM AND 2.395 INCHES MAXIMUM | | OVERALL WIDTH | 0.730 INCHES MINIMUM AND 0.790 INCHES MAXIMUM | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-18729 MIL SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL COMP 4130 | | STYLE DESIGNATOR | NON-CIRCULAR W/SQUARE CORNERS | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1 FED SPEC SINGLE TREATMENT RESPONSE | | SURFACE TREATMENT | CADMIUM | | TEST DATA DOCUMENT | 81349-MIL-I-6868 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
|
|