|
|
|
National Stock Number:
5365-01-364-8988
Federal Supply Class:
5365
National Item Identification Number:
013648988
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
|
Techincal Specification:
| BOLT HOLE QUANTITY | 2 | | BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.100 INCHES NOMINAL | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 0.680 INCHES NOMINAL | | HOLE DIAMETER | 0.109 INCHES MINIMUM AND 0.113 INCHES MAXIMUM | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.080 INCHES NOMINAL | | OVERALL LENGTH | 0.840 INCHES NOMINAL | | OVERALL THICKNESS | 0.032 INCHES NOMINAL | | OVERALL WIDTH | 0.200 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-5059 MIL SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL COMP 301 OR STEEL COMP 302 OR STEEL COMP 304 | | OUTSIDE CORNER RADIUS | 0.050 INCHES NOMINAL | | STYLE DESIGNATOR | NON-CIRCULAR W/CORNER RADIUS | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE | | SURFACE TREATMENT | PASSIVATE |
|
|