|
|
|
National Stock Number:
5365-01-454-3731
Federal Supply Class:
5365
National Item Identification Number:
014543731
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 1-819-8414-23 | 0W357 | PDI GROUND SUPPORT SYSTEMS, INC. |
|
Techincal Specification:
| APERTURE DIAMETER | 0.750 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | ASTM A514 ASSN STD SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | PROPRIETARY CHARACTERISTICS | PACS | | OVERALL LENGTH | 11.310 INCHES MINIMUM AND 11.440 INCHES MAXIMUM | | OVERALL THICKNESS | 0.500 INCHES NOMINAL | | OVERALL WIDTH | 3.440 INCHES MINIMUM AND 3.560 INCHES MAXIMUM | | SPECIAL FEATURES | HAS FOUR NOTCHES; TWO NOTCHES ARE ON EACH SIDE OF OVERALL LENGTH; EACH NOTCH HAS NOMINAL RADIUS OF 0.340 IN.; EACH NOTCH HAS MINIMUM DISTANCE OF 0.750 IN. AND MAXIMUM DISTANCE OF 0.810 IN. FROM CENTER OF NOTCH TO OUTSIDE EDGE ALONG LENGTH. | | STYLE DESIGNATOR | NON-CIRCULAR W/O BOLT HOLES |
|
|